Viewing file:  tcpm.h (5.12 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* Copyright 2015-2017 Google, Inc
*/
#ifndef __LINUX_USB_TCPM_H
#define __LINUX_USB_TCPM_H
#include <linux/bitops.h>
#include <linux/usb/typec.h>
#include "pd.h"
enum typec_cc_status {
TYPEC_CC_OPEN,
TYPEC_CC_RA,
TYPEC_CC_RD,
TYPEC_CC_RP_DEF,
TYPEC_CC_RP_1_5,
TYPEC_CC_RP_3_0,
};
enum typec_cc_polarity {
TYPEC_POLARITY_CC1,
TYPEC_POLARITY_CC2,
};
/* Time to wait for TCPC to complete transmit */
#define PD_T_TCPC_TX_TIMEOUT 100 /* in ms */
#define PD_ROLE_SWAP_TIMEOUT (MSEC_PER_SEC * 10)
#define PD_PPS_CTRL_TIMEOUT (MSEC_PER_SEC * 10)
enum tcpm_transmit_status {
TCPC_TX_SUCCESS = 0,
TCPC_TX_DISCARDED = 1,
TCPC_TX_FAILED = 2,
};
enum tcpm_transmit_type {
TCPC_TX_SOP = 0,
TCPC_TX_SOP_PRIME = 1,
TCPC_TX_SOP_PRIME_PRIME = 2,
TCPC_TX_SOP_DEBUG_PRIME = 3,
TCPC_TX_SOP_DEBUG_PRIME_PRIME = 4,
TCPC_TX_HARD_RESET = 5,
TCPC_TX_CABLE_RESET = 6,
TCPC_TX_BIST_MODE_2 = 7
};
/**
* struct tcpc_config - Port configuration
* @src_pdo: PDO parameters sent to port partner as response to
* PD_CTRL_GET_SOURCE_CAP message
* @nr_src_pdo: Number of entries in @src_pdo
* @snk_pdo: PDO parameters sent to partner as response to
* PD_CTRL_GET_SINK_CAP message
* @nr_snk_pdo: Number of entries in @snk_pdo
* @operating_snk_mw:
* Required operating sink power in mW
* @type: Port type (TYPEC_PORT_DFP, TYPEC_PORT_UFP, or
* TYPEC_PORT_DRP)
* @default_role:
* Default port role (TYPEC_SINK or TYPEC_SOURCE).
* Set to TYPEC_NO_PREFERRED_ROLE if no default role.
* @try_role_hw:True if try.{Src,Snk} is implemented in hardware
* @alt_modes: List of supported alternate modes
*/
struct tcpc_config {
const u32 *src_pdo;
unsigned int nr_src_pdo;
const u32 *snk_pdo;
unsigned int nr_snk_pdo;
const u32 *snk_vdo;
unsigned int nr_snk_vdo;
unsigned int operating_snk_mw;
enum typec_port_type type;
enum typec_port_data data;
enum typec_role default_role;
bool try_role_hw; /* try.{src,snk} implemented in hardware */
bool self_powered; /* port belongs to a self powered device */
const struct typec_altmode_desc *alt_modes;
};
/* Mux state attributes */
#define TCPC_MUX_USB_ENABLED BIT(0) /* USB enabled */
#define TCPC_MUX_DP_ENABLED BIT(1) /* DP enabled */
#define TCPC_MUX_POLARITY_INVERTED BIT(2) /* Polarity inverted */
/**
* struct tcpc_dev - Port configuration and callback functions
* @config: Pointer to port configuration
* @fwnode: Pointer to port fwnode
* @get_vbus: Called to read current VBUS state
* @get_current_limit:
* Optional; called by the tcpm core when configured as a snk
* and cc=Rp-def. This allows the tcpm to provide a fallback
* current-limit detection method for the cc=Rp-def case.
* For example, some tcpcs may include BC1.2 charger detection
* and use that in this case.
* @set_cc: Called to set value of CC pins
* @get_cc: Called to read current CC pin values
* @set_polarity:
* Called to set polarity
* @set_vconn: Called to enable or disable VCONN
* @set_vbus: Called to enable or disable VBUS
* @set_current_limit:
* Optional; called to set current limit as negotiated
* with partner.
* @set_pd_rx: Called to enable or disable reception of PD messages
* @set_roles: Called to set power and data roles
* @start_toggling:
* Optional; if supported by hardware, called to start dual-role
* toggling or single-role connection detection. Toggling stops
* automatically if a connection is established.
* @try_role: Optional; called to set a preferred role
* @pd_transmit:Called to transmit PD message
* @mux: Pointer to multiplexer data
*/
struct tcpc_dev {
const struct tcpc_config *config;
struct fwnode_handle *fwnode;
int (*init)(struct tcpc_dev *dev);
int (*get_vbus)(struct tcpc_dev *dev);
int (*get_current_limit)(struct tcpc_dev *dev);
int (*set_cc)(struct tcpc_dev *dev, enum typec_cc_status cc);
int (*get_cc)(struct tcpc_dev *dev, enum typec_cc_status *cc1,
enum typec_cc_status *cc2);
int (*set_polarity)(struct tcpc_dev *dev,
enum typec_cc_polarity polarity);
int (*set_vconn)(struct tcpc_dev *dev, bool on);
int (*set_vbus)(struct tcpc_dev *dev, bool on, bool charge);
int (*set_current_limit)(struct tcpc_dev *dev, u32 max_ma, u32 mv);
int (*set_pd_rx)(struct tcpc_dev *dev, bool on);
int (*set_roles)(struct tcpc_dev *dev, bool attached,
enum typec_role role, enum typec_data_role data);
int (*start_toggling)(struct tcpc_dev *dev,
enum typec_port_type port_type,
enum typec_cc_status cc);
int (*try_role)(struct tcpc_dev *dev, int role);
int (*pd_transmit)(struct tcpc_dev *dev, enum tcpm_transmit_type type,
const struct pd_message *msg);
};
struct tcpm_port;
struct tcpm_port *tcpm_register_port(struct device *dev, struct tcpc_dev *tcpc);
void tcpm_unregister_port(struct tcpm_port *port);
void tcpm_vbus_change(struct tcpm_port *port);
void tcpm_cc_change(struct tcpm_port *port);
void tcpm_pd_receive(struct tcpm_port *port,
const struct pd_message *msg);
void tcpm_pd_transmit_complete(struct tcpm_port *port,
enum tcpm_transmit_status status);
void tcpm_pd_hard_reset(struct tcpm_port *port);
void tcpm_tcpc_reset(struct tcpm_port *port);
#endif /* __LINUX_USB_TCPM_H */
|